Oil Temperature Sensor And Oil Pressure Sensor - APRILIA TUAREG 660 Service Station Manual

Electrical system
TABLE L2 - PROCEDURE FOR THE CORRECT
FITTING OF THE ABS CONTROL UNIT CON-
NECTOR
•
When the connector is fully inserted,
the distance between the connector
and the ABS control unit must be 7.5
mm.
TABLE L3 - PROCEDURE FOR THE CORRECT
FITTING OF THE ABS CONTROL UNIT CON-
NECTOR
•
If the initial position of the connector
and lever is not as indicated in the "TA-
BLE L", the connector will not couple
correctly and the distance measure-
ment will be greater (approx. 12 mm).
•
In this case, repeat the operation de-
scribed in "TABLES L1/L2".
•
We recommend creating a template in
order to ensure that the connector is
inserted correctly.
TABLE L4 - PROCEDURE FOR THE CORRECT
FITTING OF THE ABS CONTROL UNIT CON-
NECTOR
•
It is possible to check the correct in-
sertion of the connector on the motor-
cycle by verifying that the yellow line is
"Flush" with the connector.
TABLE M - OIL TEMPERATURE SENSOR AND
OIL PRESSURE SENSOR
•
Correctly connect the connector (1) of
the oil temperature sensor and of the
oil pressure sensor (2) securing the
wiring harness by means of a clamp in
the point indicated.
ELE SYS - 84
TUAREG 660