Dual Homed Rings Configuration Example - HPE FlexNetwork HSR6800 series Configuration Manual

[RouterE] rrpp enable
6. Verify the configuration:
Use the display command to view RRPP configuration and operational information on each
device.

Dual homed rings configuration example

Networking requirements
As shown in
•
Router A through Router H form RRPP domain 1. Specify the primary control VLAN of RRPP
domain 1 as VLAN 4092, and specify that RRPP domain 1 protects VLANs 1 through 30.
•
Router A through Router D form primary ring 1. Router A, Router B, and Router E form subring
2. Router A, Router B, and Router F form subring 3. Router C, Router D, and Router G form
subring 4. Router C, Router D, and Router H form subring 5.
•
Specify Router A as the master node of primary ring 1, GigabitEthernet 3/0/1 as the primary port
and GigabitEthernet 3/0/2 as the secondary port. Specify Router E as the master node of
subring 2, GigabitEthernet 3/0/1 as the primary port and GigabitEthernet 3/0/2 as the secondary
port. Specify Router F as the master node of subring 3, GigabitEthernet 3/0/1 as the primary
port and GigabitEthernet 3/0/2 as the secondary port. Specify Router G as the master node of
subring 4, GigabitEthernet 3/0/1 as the primary port and GigabitEthernet 3/0/2 as the secondary
port. Specify Router H as the master node of subring 5, GigabitEthernet 3/0/1 as the primary
port and GigabitEthernet 3/0/2 as the secondary port.
•
Specify Router A as the edge node of the connected subrings, its GigabitEthernet 3/0/3 and
GigabitEthernet 3/0/4 as the edge ports. Specify Router D as the transit node of the primary ring
and edge node of the connected subrings, its GigabitEthernet 3/0/3 and GigabitEthernet 3/0/4
as the edge ports. Specify Router B and Router C as the transit node of the primary ring and
assistant-edge nodes of the connected subrings, their GigabitEthernet 3/0/3 and
GigabitEthernet 3/0/4 as the edge ports.
NOTE:
Configure the primary and secondary ports on the master nodes correctly to make sure that other
protocols still work correctly when data VLANs are denied by the secondary ports.
Figure 26,
92