HPE FlexNetwork HSR6800 series Configuration Manual page 126

Figure 29 Network diagram
Configuration procedure
1. Configure Router C:
# Create VLANs 1 through 30, map these VLANs to MSTI 1, and activate the MST region
configuration.
<RouterC> system-view
[RouterC] vlan 1 to 30
[RouterC] stp region-configuration
[RouterC-mst-region] instance 1 vlan 1 to 30
[RouterC-mst-region] active region-configuration
[RouterC-mst-region] quit
# Shut down GigabitEthernet 3/0/1 and GigabitEthernet 3/0/2, disable the spanning tree feature
on GigabitEthernet 3/0/1 and GigabitEthernet 3/0/2 separately, configure them as trunk ports,
and assign them to VLANs 1 through 30.
[RouterC] interface gigabitethernet 3/0/1
[RouterC-GigabitEthernet3/0/1] shutdown
[RouterC-GigabitEthernet3/0/1] undo stp enable
[RouterC-GigabitEthernet3/0/1] port link-type trunk
[RouterC-GigabitEthernet3/0/1] port trunk permit vlan 1 to 30
[RouterC-GigabitEthernet3/0/1] quit
[RouterC] interface gigabitethernet 3/0/2
[RouterC-GigabitEthernet3/0/2] shutdown
[RouterC-GigabitEthernet3/0/2] undo stp enable
[RouterC-GigabitEthernet3/0/2] port link-type trunk
[RouterC-GigabitEthernet3/0/2] port trunk permit vlan 1 to 30
[RouterC-GigabitEthernet3/0/2] quit
# Create smart link group 1, and configure all VLANs mapped to MSTI 1 as the protected
VLANs.
[RouterC] smart-link group 1
[RouterC-smlk-group1] protected-vlan reference-instance 1
# Configure GigabitEthernet 3/0/1 as the primary port and GigabitEthernet 3/0/2 as the
secondary port for smart link group 1.
[RouterC-smlk-group1] port gigabitethernet3/0/1 master
[RouterC-smlk-group1] port gigabitethernet3/0/2 slave
119