Rrpp Configuration Task List; Creating An Rrpp Domain - HPE FlexNetwork HSR6800 series Configuration Manual

RRPP configuration task list

You can create RRPP domains based on service planning, specify control VLANs and data VLANs
for each RRPP domain, and then determine the ring roles and node roles based on the traffic paths
in each RRPP domain.
RRPP does not have an auto election mechanism, so you must configure each node in the ring
network correctly for RRPP to monitor and protect the ring network.
Before configuring RRPP, you must physically construct a ring-shaped Ethernet topology.
Complete the following tasks to configure RRPP:
Task

Creating an RRPP domain

Configuring control VLANs
Configuring protected VLANs
Configuring
RRPP rings
Activating an RRPP domain
Configuring RRPP timers
Configuring an RRPP ring group
Creating an RRPP domain
When creating an RRPP domain, specify a domain ID, which uniquely identifies an RRPP domain.
All devices in the same RRPP domain must be configured with the same domain ID.
Make this configuration on devices you want to configure as nodes in the RRPP domain.
To create an RRPP domain:
Step
1. Enter system view.
2. Create an RRPP domain and enter RRPP
domain view.
Configuring RRPP ports
Configuring RRPP nodes
Remarks
Required.
Perform this task on all nodes in the RRPP domain.
Required.
Perform this task on all nodes in the RRPP domain.
Required.
Perform this task on all nodes in the RRPP domain.
Required.
Perform this task on all nodes in the RRPP domain.
Required.
Perform this task on all nodes in the RRPP domain.
Required.
Perform this task on all nodes in the RRPP domain.
Optional.
Perform this task on the master node in the RRPP
domain.
Optional.
Perform this task on the edge node and assistant-edge
node in the RRPP domain.
Command
system-view
rrpp domain domain-id
78