HPE FlexNetwork HSR6800 series Configuration Manual page 252

continuity check message frame (CFD), 20
linktrace message frame (CFD), 21
multi-hop detection (BFD), 194
multiple groups configuration (Smart Link), 123
N
neighbor
setting DLDP mode, 39
two-way (DLDP state), 37
unidirectional (DLDP state), 37
unknown (DLDP state), 37
network
activating RRPP domain, 82
CFD MEP list, 20
configuring RRPP control VLAN, 79
configuring RRPP node, 81
configuring RRPP port, 80
configuring RRPP protected VLAN, 79
configuring RRPP ring, 80
configuring Smart Link device, 114
enabling DLDP, 39
performing active switchover manually, 6
performing standby switchover manually, 6
restarting standby MPU, 6
RRPP control VLAN, 71
RRPP data VLAN, 71
RRPP domain, 70
RRPP load balancing, 74
RRPP ring group, 74
Smart Link load sharing mechanism, 113
Smart Link primary link, 112
Smart Link primary port, 112
Smart Link secondary link, 112
Smart Link secondary port, 112
VRRP application, 137
networking
RRPP intersecting rings load balancing, 77
RRPP intersecting rings topology, 75
RRPP single ring load balancing, 76
RRPP single ring topology, 74
RRPP tangent rings topology, 75
node
configuring RRPP node, 81
RRPP assistant-edge type, 71
RRPP edge type, 71
RRPP master type, 71
RRPP transit type, 71
specifying RRPP assistant-edge node, 82
specifying RRPP edge node, 82
specifying RRPP master node, 81
specifying RRPP transit node, 81
normal mode (DLDP), 39
NQA
associating with Track, 204
configuring static routing-Track-NQA
collaboration, 220
high availability fault detection technologies, 2
VRRP-Track-NQA collaboration
configuration, 210
NSR (high availability protection switchover
technology), 3
O
open ring
edge, 50
operating mode
VRRP load-balancing, 132, 138
VRRP standard, 132
operation mode
BFD active, 195
BFD passive, 195
DLDP enhanced, 33
DLDP normal, 33
operation, administration and maintenance. Use OAM
OSPF
BFD supported features, 198
v3 BFD supported features, 198
P
packet
BFD format, 196
configuring IPv4 VRRP attribute, 150
configuring IPv6 VRRP attribute, 156
DLDP processing by type, 35
DLDP state and packet type, 35
setting DLDP send advertisement packet
interval, 39
VRRP format, 134
parameter (BFD dynamic change), 196
passive operation mode (BFD), 195
performance monitoring (Ethernet OAM), 7
performing
active switchover manually, 6
standby switchover manually, 6
PIM (BFD supported feature), 198
ping, 20, See also loopback (CFD)
polling mechanism (RRPP), 73
port
configuring member port for Smart Link
group, 115
configuring member port in interface view, 116
configuring member port in Smart Link group
view, 115
245