Configuring Control Vlans; Configuring Protected Vlans - HPE FlexNetwork HSR6800 series Configuration Manual

Configuring control VLANs

Before configuring RRPP rings in an RRPP domain, configure the same control VLANs for all nodes
in the RRPP domain first.
Perform this configuration on all nodes in the RRPP domain to be configured.
Follow these guidelines when you configure control VLANs:
•
When you configure existing VLANs as primary control VLANs or secondary control VLANs, the
system prompts errors.
•
To ensure proper forwarding of RRPPDUs, do not enable 802.1Q in 802.1Q (QinQ) or VLAN
mapping on the control VLANs.
•
To make sure that RRPPDUs can be sent and received correctly, do not configure the default
VLAN of a port accessing an RRPP ring as the primary control VLAN or the secondary control
VLAN.
•
To transparently transmit RRPPDUs on a device not configured with RRPP, you must make
sure that only the two ports connecting the device to the RRPP ring permit packets from the
control VLANs. Otherwise, the packets from other VLANs might enter the control VLANs in
transparent transmission mode and strike the RRPP ring.
To configure control VLANs:
Step
1. Enter system view.
2. Enter RRPP domain view.
3. Configure the primary control VLAN for the
RRPP domain.

Configuring protected VLANs

Before configuring RRPP rings in an RRPP domain, configure the same protected VLANs for all
nodes in the RRPP domain first. All VLANs that the RRPP ports are assigned to should be protected
by the RRPP domains.
You can configure protected VLANs through referencing Multiple Spanning Tree Instances (MSTIs).
Before configuring protected VLANs, configure the mappings between MSTIs and the VLANs to be
protected (a device working in PVST mode automatically maps VLANs to MSTIs). For more
information about MSTIs and PVST, see Layer 2—LAN Switching Configuration Guide.
Perform this configuration on all nodes in the RRPP domain to be configured.
IMPORTANT:
When configuring load balancing, you must configure different protected VLANs for different RRPP
domains.
To configure protected VLANs:
Step
1. Enter system view.
Command
system-view
rrpp domain domain-id
control-vlan vlan-id
Command
system-view
79
Remarks
N/A