HPE FlexNetwork HSR6800 series Configuration Manual page 179

Forwarder Weight Track Information:
Track Object
Forwarder Switchover Track Information:
Track Object
Member IP
Track Object
Member IP
The output shows that when GigabitEthernet 1/0/2 on Router A fails, the weight of the AVF on
Router A decreases to 5, which is lower than the lower limit of failure. All VFs on Router A turn
to initialized state and cannot be used for packet forwarding. The VF corresponding to MAC
address 000f-e2ff-0011 on Router C becomes the AVF, and Router C takes over Router A for
packet forwarding.
# When the timeout timer (about 1800 seconds) expires, display the detailed information about
VRRP group 1 on Router C.
[RouterC] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface GigabitEthernet1/0/1
VRID
Admin Status
Config Pri
Preempt Mode
Become Master
Auth Type
Virtual IP
Member IP List : 10.1.1.4 (Local, Backup)
Forwarder Information: 2 Forwarders 1 Active
Config Weight
Running Weight : 255
Forwarder 02
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 03
State
Virtual MAC
Owner ID
Priority
Active
Forwarder Weight Track Information:
Track Object
Forwarder Switchover Track Information:
Track Object
: 1 State : Positive
: 2 State : Positive
: 10.1.1.2
: 3 State : Positive
: 10.1.1.3
: Load Balance
: Virtual MAC
: 1 Adver Timer
: Up State
: 100 Running Pri
: Yes Delay Time
: 4200ms left
: None
: 10.1.1.1
10.1.1.2 (Master)
10.1.1.3 (Backup)
: 255
: Listening
: 000f-e2ff-0012 (Learnt)
: 0000-5e01-1103
: 127
: 10.1.1.3
: Active
: 000f-e2ff-0013 (Owner)
: 0000-5e01-1105
: 255
: local
: 1 State : Positive
: 2 State : Positive
172
Weight Reduced : 250
: 1
: Backup
: 100
: 5
Weight Reduced : 250