Binding An Rpr Logical Interface With Rpr Physical Ports; Enabling Rpr Mate Port Smart Connection - HPE FlexNetwork HSR6800 series Configuration Manual

Step
5. Specify the card for forwarding
traffic of the interface.
6. Set the maximum available
bandwidth for the interface.
7. Shut down the interface.

Binding an RPR logical interface with RPR physical ports

To create an RPR station, you must create an RPR logical interface first and then bind RPR physical
ports with the interface. You might bind RPR physical ports with an RPR logical interface in RPR
logical interface view or RPR physical port view. In either case, you must create the RPR logical
interface first.
Binding RPR physical ports with an RPR logical interface in RPR logical interface view
Step
1. Enter system view.
2. Enter RPR logical
interface view.
3. Bind an RPR
physical port with the
RPR logical
interface.
Binding RPR physical ports with an RPR logical interface in RPR physical port view
Step
1. Enter system view.
2. Enter RPR physical
port view.
3. Bind the RPR logical
interface with the
RPR physical port.

Enabling RPR mate port smart connection

For an RPR station to forward traffic, before binding its two RPR physical ports with the same logical
RPR interface, you must connect their mate ports.
When the two RPR physical ports are on the same subcard, that is, in centralized RPR, you can
enable the RPR mate port smart connection function. With the function enabled, RPR automatically
connects the two mate ports without you having to connect them manually.
Command
In standalone mode:
service slot slot-number
In IRF mode:
service chassis
chassis-number slot
slot-number
bandwidth bandwidth-value
shutdown
Command
system-view
interface rpr interface-number
rpr bind { rprpos
interface-number } { ringlet0 |
ringlet1 }
Command
system-view
interface rprpos
interface-number
rpr bind { rpr
interface-number } { ringlet0 |
ringlet1 }
58
Remarks
Optional.
By default, the card where the
receiving member port resides
processes the traffic.
Do not use the service command
to configure the MPU to forward
traffic of the interface on an
HSR6800 router, because traffic
forwarding is performed by LPUs
on these routers.
Optional.
Optional.
Enabled by default.
Remarks
N/A
N/A
By default, no RPR physical ports are
bound with an RPR logical interface.
Remarks
N/A
N/A
By default, no RPR physical ports are bound
with an RPR logical interface.