Ipv6-Based Vrrp Configuration Examples; Single Vrrp Group Configuration Example - HPE FlexNetwork HSR6800 series Configuration Manual

VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Member IP List : 10.1.1.4 (Local, Master)
Forwarder Information: 2 Forwarders 2 Active
Config Weight
Running Weight : 255
Forwarder 02
State
Virtual MAC
Owner ID
Priority
Active
Redirect Time
Time-out Time
Forwarder 03
State
Virtual MAC
Owner ID
Priority
Active
Forwarder Weight Track Information:
Track Object
Forwarder Switchover Track Information:
Track Object
Track Object
The output shows that when Router B fails, Router C becomes the master, and Forwarder 02
on Router C immediately becomes active. Router C takes over the AVF on Router B.

IPv6-based VRRP configuration examples

Single VRRP group configuration example

Network requirements
•
Router A and Router B belong to VRRP group 1 with the virtual IPv6 addresses of 1::10/64 and
FE80::10.
•
Host A wants to access Host B on the Internet. Host A learns 1::10/64 as its default gateway
through the RA messages sent by the routers.
•
When Router A operates correctly, packets sent from Host A to Host B are forwarded by Router
A. When Router A fails, packets sent from Host A to Host B are forwarded by Router B.
: 1
: Up
: 100
: Yes
: None
: 10.1.1.1
: 255
: Active
: 000f-e2ff-0012 (Take Over)
: 0000-5e01-1103
: 85
: local
: 93 secs
: 1293 secs
: Active
: 000f-e2ff-0013 (Owner)
: 0000-5e01-1105
: 255
: local
: 1
: 2
Member IP : 10.1.1.2
: 3
Member IP : 10.1.1.3
Adver Timer : 1
State : Master
Running Pri : 100
Delay Time : 5
State : Positive
State : Negative
State : Negative
174
Weight Reduced : 250