Configuring The Rpr Station Name; Configuring Rpr Protection; Configuring The Rpr Protection Mode; Configuring Rpr Protection Reversion Mode - HPE FlexNetwork HSR6800 series Configuration Manual

To enable RPR mate port smart connection:
Step
1. Enter system view.
2. Enter RPR logical
interface view.
3. Enable RPR mate port
smart connection.

Configuring the RPR station name

Step
1. Enter system view.
2. Enter RPR logical
interface view.
3. Configure a station
name.

Configuring RPR protection

Configuring the RPR protection mode

All the stations on an RPR ring must adopt the same protection mode for the ring to operate correctly.
To configure the protection mode on the RPR station:
Step
1. Enter system view.
2. Enter RPR logical
interface view.
3. Configure the
protection mode.

Configuring RPR protection reversion mode

The following protection reversion modes are available: revertive and non-revertive.
•
Revertive mode—A station resumes the idle protection state once the WTR timer expires.
•
Non-revertive mode—The station remains in automatic protection state upon expiration of the
WTR timer and does not resume the idle state until a higher protection request is present on the
ring.
To configure the RPR protection reversion mode on the RPR station:
Step
1. Enter system view.
Command
system-view
interface rpr
interface-number
rpr mate smart-connect
Command
system-view
interface rpr interface-number
rpr station-name station-name
Command
system-view
interface rpr interface-number
rpr protect-mode { steer |
wrap }
Command
system-view
59
Remarks
N/A
N/A
Disabled by default.
Remarks
N/A
N/A
No station name is configured by default.
Remarks
N/A
N/A
By default, the steering mode applies.
Remarks
N/A