Configuring Vrrp Packet Attributes; Displaying And Maintaining Vrrp For Ipv6 - HPE FlexNetwork HSR6800 series Configuration Manual

Configuring VRRP packet attributes

Configuration prerequisites
Before you configure the relevant attributes of VRRP packets, create a VRRP group and configure a
virtual IPv6 address.
Configuration guidelines
•
You might configure different authentication modes and authentication keys for the VRRP
groups on an interface. However, the members of the same VRRP group must use the same
authentication mode and authentication key.
•
Excessive traffic might cause a backup to trigger a change of its status because the backup
does not receive any VRRP advertisements for a specified period of time. To solve this problem,
prolong the time interval to send VRRP advertisements.
•
Configuring different intervals for sending VRRP advertisements on the routers in a VRRP
group might cause a backup to trigger a change of its status because the backup does not
receive any VRRP advertisements for a specified period of time. To solve this problem,
configure the same interval for sending VRRP advertisements on each router in the VRRP
group.
Configuration procedure
To configure VRRP packet attributes:
Step
1. Enter system view.
2. Enter the specified interface
view.
3. Configure the authentication
mode and authentication key
when the VRRP groups send
or receive VRRP packets.
4. Configure the time interval
for the master in the VRRP
group to send VRRP
advertisement.

Displaying and maintaining VRRP for IPv6

Task
Display VRRP group status.
Display VRRP group statistics.
Command
system-view
interface interface-type
interface-number
vrrp ipv6 vrid virtual-router-id
authentication-mode simple
[ cipher ] key
vrrp ipv6 vrid virtual-router-id
timer advertise adver-interval
Command
display vrrp ipv6 [ verbose ]
[ interface interface-type
interface-number [ vrid
virtual-router-id ] ] [ | { begin |
exclude | include }
regular-expression ]
display vrrp ipv6 statistics
[ interface interface-type
interface-number [ vrid
virtual-router-id ] ] [ | { begin |
exclude | include }
regular-expression ]
156
Remarks
N/A
N/A
Optional.
Authentication is not performed
by default.
Optional.
100 centiseconds by default.
Remarks
Available in any view.
Available in any view.