HPE FlexNetwork HSR6800 series Configuration Manual page 127

# Enable flush message sending in smart link group 1, and configure VLAN 10 as the transmit
control VLAN.
[RouterC-smlk-group1] flush enable control-vlan 10
[RouterC-smlk-group1] quit
# Bring up GigabitEthernet 3/0/1 and GigabitEthernet 3/0/2 again.
[RouterC] interface gigabitethernet 3/0/1
[RouterC-GigabitEthernet3/0/1] undo shutdown
[RouterC-GigabitEthernet3/0/1] quit
[RouterC] interface gigabitethernet 3/0/2
[RouterC-GigabitEthernet3/0/2] undo shutdown
[RouterC-GigabitEthernet3/0/2] quit
2. Configure Router D:
# Create VLANs 1 through 30, map these VLANs to MSTI 1, and activate the MST region
configuration.
<RouterD> system-view
[RouterD] vlan 1 to 30
[RouterD] stp region-configuration
[RouterD-mst-region] instance 1 vlan 1 to 30
[RouterD-mst-region] active region-configuration
[RouterD-mst-region] quit
# Shut down GigabitEthernet 3/0/1 and GigabitEthernet 3/0/2, disable the spanning tree feature
on GigabitEthernet 3/0/1 and GigabitEthernet 3/0/2 separately, configure them as trunk ports,
and assign them to VLANs 1 through 30.
[RouterD] interface gigabitethernet 3/0/1
[RouterD-GigabitEthernet3/0/1] shutdown
[RouterD-GigabitEthernet3/0/1] undo stp enable
[RouterD-GigabitEthernet3/0/1] port link-type trunk
[RouterD-GigabitEthernet3/0/1] port trunk permit vlan 1 to 30
[RouterD-GigabitEthernet3/0/1] quit
[RouterD] interface gigabitethernet 3/0/2
[RouterD-GigabitEthernet3/0/2] shutdown
[RouterD-GigabitEthernet3/0/2] undo stp enable
[RouterD-GigabitEthernet3/0/2] port link-type trunk
[RouterD-GigabitEthernet3/0/2] port trunk permit vlan 1 to 30
[RouterD-GigabitEthernet3/0/2] quit
# Create smart link group 1, and configure all VLANs mapped to MSTI 1 as the protected
VLANs.
[RouterD] smart-link group 1
[RouterD-smlk-group1] protected-vlan reference-instance 1
# Configure GigabitEthernet 3/0/1 as the primary port and GigabitEthernet 3/0/2 as the
secondary port for smart link group 1.
[RouterD-smlk-group1] port gigabitethernet3/0/1 master
[RouterD-smlk-group1] port gigabitethernet3/0/2 slave
# Enable flush message sending in smart link group 1, and configure VLAN 20 as the transmit
control VLAN.
[RouterD-smlk-group1] flush enable control-vlan 20
[RouterD-smlk-group1] quit
# Bring up GigabitEthernet 3/0/1 and GigabitEthernet 3/0/2 again.
[RouterD] interface gigabitethernet 3/0/1
120