Multiple Vrrp Groups Configuration Example - HPE FlexNetwork HSR6800 series Configuration Manual

[RouterA-GigabitEthernet1/0/1] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface GigabitEthernet1/0/2
VRID
Admin Status
Config Pri
Preempt Mode
Become Master
Auth Type
Virtual IP
Master IP
VRRP Track Information:
Track Interface: GE1/0/1
# If interface GigabitEthernet 1/0/1 on Router A is not available, the detailed information about
VRRP group 1 on Router B is displayed.
[RouterB] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface GigabitEthernet1/0/2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
The output shows that if interface GigabitEthernet 1/0/1 on Router A is not available, the priority
of Router A is reduced to 80 and it becomes the backup. Router B becomes the master and
packets sent from Host A to Host B are forwarded by Router B.

Multiple VRRP groups configuration example

Network requirements
•
In the segment 202.38.160.0/24, some hosts use 202.38.160.111/24 as their default gateway
and some hosts use 202.38.160.112/24 as their default gateway.
•
Load sharing and mutual backup between default gateways can be implemented by using
VRRP groups.
: Standard
: Virtual MAC
: 1 Adver Timer
: Up State
: 110 Running Pri
: Yes Delay Time
: 4200ms left
: Simple Key
: 202.38.160.111
: 202.38.160.2
State : Down
: Standard
: Virtual MAC
: 1 Adver Timer
: Up State
: 100 Running Pri
: Yes Delay Time
: Simple Key
: 202.38.160.111
: 0000-5e00-0101
: 202.38.160.2
162
: 4
: Backup
: 80
: 5
: hello
Pri Reduced : 30
: 4
: Master
: 100
: 5
: hello