HPE FlexNetwork HSR6800 series Configuration Manual page 180

Member IP
Track Object
Member IP
The output shows that when the timeout timer expires, the VF corresponding to virtual MAC
address 000f-e2ff-0011 is removed, and no longer forwards the packets destined for the MAC
address.
# When Router A fails, use the display vrrp verbose command to display the detailed
information about VRRP group 1 on Router B.
[RouterB] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface GigabitEthernet1/0/1
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Member IP List : 10.1.1.3 (Local, Master)
Forwarder Information: 2 Forwarders 1 Active
Config Weight
Running Weight : 255
Forwarder 02
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 03
State
Virtual MAC
Owner ID
Priority
Active
Forwarder Weight Track Information:
Track Object
The output shows that when Router A fails, Router B becomes the master because its priority is
higher than that of Router C.
# When Router B fails, use the display vrrp verbose command to display the detailed
information about VRRP group 1 on Router C.
[RouterC] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface GigabitEthernet1/0/1
: 10.1.1.2
: 3 State : Positive
: 10.1.1.3
: Load Balance
: Virtual MAC
: 1 Adver Timer
: Up State
: 110 Running Pri
: Yes Delay Time
: None
: 10.1.1.1
10.1.1.4 (Backup)
: 255
: Active
: 000f-e2ff-0012 (Owner)
: 0000-5e01-1103
: 255
: local
: Listening
: 000f-e2ff-0013 (Learnt)
: 0000-5e01-1105
: 127
: 10.1.1.4
: 1 State : Positive
: Load Balance
: Virtual MAC
173
: 1
: Master
: 110
: 5
Weight Reduced : 250