HPE FlexNetwork HSR6800 series Configuration Manual page 189

# Create VRRP group 1 and set its virtual IPv6 addresses to FE80::10 and 1::10.
[RouterB-GigabitEthernet1/0/1] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
[RouterB-GigabitEthernet1/0/1] vrrp ipv6 vrid 1 virtual-ip 1::10
# Create VRRP group 2 set its virtual IPv6 addresses to FE80::20 and 1::20.
[RouterB-GigabitEthernet1/0/1] vrrp ipv6 vrid 2 virtual-ip fe80::20 link-local
[RouterB-GigabitEthernet1/0/1] vrrp ipv6 vrid 2 virtual-ip 1::20
# Set the priority of Router B in VRRP group 2 to 110, which is higher than that of Router A (100),
so that Router B can become the master in VRRP group 2.
[RouterB-GigabitEthernet1/0/1] vrrp ipv6 vrid 2 priority 110
3. Verify the configuration:
To verify your configuration, use the display vrrp ipv6 verbose command.
# Display the detailed information about the VRRP group on Router A.
[RouterA] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 2
Interface GigabitEthernet1/0/1
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
Interface GigabitEthernet1/0/1
VRID
Admin Status
Config Pri
Preempt Mode
Become Master
Auth Type
Virtual IP
Master IP
# Display the detailed information about the VRRP group on Router B.
[RouterB] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 2
Interface GigabitEthernet1/0/1
VRID
Admin Status
Config Pri
Preempt Mode
: Standard
: Virtual MAC
: 1 Adver Timer
: Up State
: 110 Running Pri
: Yes Delay Time
: None
: FE80::10
1::10
: 0000-5e00-0201
: FE80::1
: 2 Adver Timer
: Up State
: 100 Running Pri
: Yes Delay Time
: 2200ms left
: None
: FE80::20
1::20
: FE80::2
: Standard
: Virtual MAC
: 1 Adver Timer
: Up State
: 100 Running Pri
: Yes Delay Time
182
: 100
: Master
: 110
: 0
: 100
: Backup
: 100
: 0
: 100
: Backup
: 100
: 0