Displaying And Maintaining Smart Link; Smart Link Configuration Examples; Single Smart Link Group Configuration Example - HPE FlexNetwork HSR6800 series Configuration Manual

To enable the receiving of flush messages:
Step
1. Enter system view.
2. Enter Ethernet interface
view or Layer 2 aggregate
interface view.
3. Configure the control VLANs
for receiving flush
messages.

Displaying and maintaining Smart Link

Task
Display smart link group
information.
Display information about the
received flush messages.
Clear the statistics about flush
messages.

Smart Link configuration examples

Single smart link group configuration example

Network requirements
As shown in
•
Router C and Router D are Smart Link devices. Router A, Router B, and Router E are
associated devices. Traffic of VLANs 1 through 30 on Router C and Router D are dually
uplinked to Router A.
•
Configure Smart Link on Router C and Router D for dual uplink backup.
Command
system-view
interface interface-type
interface-number
smart-link flush enable
[ control-vlan vlan-id-list ]
Command
display smart-link group { group-id | all } [ |
{ begin | exclude | include } regular-expression ]
display smart-link flush [ | { begin | exclude |
include } regular-expression ]
reset smart-link statistics
Figure 29:
118
Remarks
N/A
N/A
By default, no control VLAN exists
for receiving flush messages.
Remarks
Available in any view.
Available in any view.
Available in user view.