HPE FlexNetwork HSR6800 series Configuration Manual page 249

RRPPDU type, 72
timer (RRPP), 73
high availability
active switchover configuration, 5, 5
adding static ringlet selection entry, 60
BFD for a VRRP backup configuration to
monitor the master, 214
BFD for VRRP master configuration to monitor
the uplink, 217
binding RPR logical interface with RPR
physical port, 58
CFD configuration, 18, 21, 22, 27
configuring ATD timer, 62
configuring default ringlet selection, 61
configuring hold off timer, 63
configuring keepalive timer, 63
configuring reserved bandwidth or rate
limiting, 61
configuring ringlet selection table, 60
configuring router priority, preemptive mode
and tracking function, 147, 154
configuring RPR basic function, 57
configuring RPR fairness algorithm, 61
configuring RPR logical interface, 57
configuring RPR physical port, 57
configuring RPR protection, 59
configuring RPR protection mode, 59
configuring RPR protection reversion
mode, 59
configuring RPR station name, 59
configuring RPR timer, 62
configuring station weight, 62
configuring TC timer, 63
configuring topology stability timer, 63
configuring TP timer, 64
configuring VF tracking, 148, 155
configuring virtual IP address, 146
configuring WTR timer, 64
creating RPR logical interface, 57
creating VRRP group, 146
displaying active switchover, 6
displaying BFD, 200
displaying CFD, 26
displaying DLDP, 42
displaying IPv4 VRRP, 151
displaying IPv6 VRRP, 156
displaying RRPP, 84
displaying Smart Link, 118
displaying standby switchover, 6
displaying track entries, 210
DLDP configuration, 31, 32, 38, 42
enabling ARP entry backup, 149
enabling RPR mate port smart connection, 58
Ethernet OAM. See Ethernet OAM
evaluation, 1
fault detection technologies, 2
ignoring standby MPU version check, 5
IPv4 VRRP configuration, 143
IPv4 VRRP interface tracking configuration, 159
IPv4 VRRP single group configuration, 157
IPv6 VRRP configuration, 151
maintaining BFD, 200
maintaining CFD, 26
maintaining DLDP, 42
maintaining IPv4 VRRP, 151
maintaining IPv6 VRRP, 156
maintaining RRPP, 84
maintaining Smart Link, 118
manually sending protection request, 60
MTBF, 1
MTTR, 1
performing active switchover manually, 6
performing standby switchover manually, 6
protection switchover technologies, 3
remote loopback (Ethernet OAM), 7
requirements, 1
restarting standby MPU, 6
RPR configuration, 50, 56, 66
RPR interface binding configuration, 66
RPR protection mode/static ringlet selection
configuration, 68
RRPP configuration, 70, 78, 84
RRPP dual homed rings configuration, 92
RRPP intersecting rings configuration, 87
RRPP load balanced intersecting rings
configuration, 101
RRPP single ring configuration, 84
Smart Link and CFD continuity check
collaboration configuration, 127
Smart Link configuration, 111, 114, 118
Smart Link multiple groups configuration, 123
Smart Link single group configuration, 118
specifying VRRP control VLAN, 144
standby switchover configuration, 5, 5
static routing-Track-BFD collaboration
configuration, 225
static routing-Track-NQA collaboration
configuration, 220
technologies, 2
testing RPR station connectivity, 64
Track configuration, 202, 203
troubleshooting DLDP, 49
242