Configuring Role Preemption For A Smart Link Group; Enabling The Sending Of Flush Messages - HPE FlexNetwork HSR6800 series Configuration Manual

Step
3. Configure member ports for a smart link group.
In interface view
To configure member ports for a smart link group in interface view:
Step
1. Enter system view.
2. Enter Ethernet interface view or layer 2
aggregate interface view.
3. Configure member ports for a smart link group.

Configuring role preemption for a smart link group

Step
1. Enter system view.
2. Create a smart link group
and enter smart link group
view.
3. Enable role preemption.
4. Configure the preemption
delay.

Enabling the sending of flush messages

Follow these guidelines when you enable the sending of flush messages:
•
The control VLAN configured for a smart link group must be different from that configured for
any other smart link group.
•
Make sure that the configured control VLAN already exists, and assign the smart link group
member ports to the control VLAN.
•
The control VLAN of a smart link group should also be one of its protected VLANs. Do not
remove the control VLAN. Otherwise, flush messages cannot be sent correctly.
To enable the sending of flush messages:
Step
1. Enter system view.
2. Create a smart link group
and enter smart link group
view.
Command
port interface-type interface-number { master |
slave }
Command
system-view
interface interface-type interface-number
port smart-link group group-id { master | slave }
Command
system-view
smart-link group group-id
preemption mode role
preemption delay delay-time
Command
system-view
smart-link group group-id
116
Remarks
N/A
N/A
N/A
Optional.
1 second by default.
The preemption delay
configuration takes effect only
after role preemption is enabled.
Remarks
N/A
N/A