HPE FlexNetwork HSR6800 series Configuration Manual page 129

# Configure GigabitEthernet 3/0/2 as a trunk port, and assign it to VLANs 1 through 30. Disable
the spanning tree feature and enable flush message receiving on it, and configure VLAN 10 as
the receive control VLAN.
[RouterE] interface gigabitethernet 3/0/2
[RouterE-GigabitEthernet3/0/2] port link-type trunk
[RouterE-GigabitEthernet3/0/2] port trunk permit vlan 1 to 30
[RouterE-GigabitEthernet3/0/2] undo stp enable
[RouterE-GigabitEthernet3/0/2] smart-link flush enable control-vlan 10
[RouterE-GigabitEthernet3/0/2] quit
# Configure GigabitEthernet 3/0/3 as a trunk port, and assign it to VLANs 1 through 30. Disable
the spanning tree feature and enable flush message receiving on it, and configure VLAN 20 as
the receive control VLAN.
[RouterE] interface gigabitethernet 3/0/3
[RouterE-GigabitEthernet3/0/3] port link-type trunk
[RouterE-GigabitEthernet3/0/3] port trunk permit vlan 1 to 30
[RouterE-GigabitEthernet3/0/3] undo stp enable
[RouterE-GigabitEthernet3/0/3] smart-link flush enable control-vlan 20
[RouterE-GigabitEthernet3/0/3] quit
5. Configure Router A:
# Create VLANs 1 through 30.
<RouterA> system-view
[RouterA] vlan 1 to 30
# Configure GigabitEthernet 3/0/1 and GigabitEthernet 3/0/2 as trunk ports, assign them to
VLANs 1 through 30, enable flush message receiving on them, and configure VLAN 10 and
VLAN 20 as the receive control VLANs.
[RouterA] interface gigabitethernet 3/0/1
[RouterA-GigabitEthernet3/0/1] port link-type trunk
[RouterA-GigabitEthernet3/0/1] port trunk permit vlan 1 to 30
[RouterA-GigabitEthernet3/0/1] smart-link flush enable control-vlan 10 20
[RouterA-GigabitEthernet3/0/1] quit
[RouterA] interface gigabitethernet 3/0/2
[RouterA-GigabitEthernet3/0/2] port link-type trunk
[RouterA-GigabitEthernet3/0/2] port trunk permit vlan 1 to 30
[RouterA-GigabitEthernet3/0/2] smart-link flush enable control-vlan 10 20
[RouterA-GigabitEthernet3/0/2] quit
6. Verify the configuration:
Use the display smart-link group command to display the smart link group configuration on a
device.
# Display the smart link group configuration on Router C.
[RouterC] display smart-link group 1
Smart link group 1 information:
Device ID: 000f-e23d-5af0
Preemption mode: NONE
Preemption delay: 1(s)
Control VLAN: 1
Protected VLAN: Reference Instance 1
Member
-----------------------------------------------------------------------------
GigabitEthernet3/0/1
Role State Flush-count Last-flush-time
MASTER ACTVIE
122
5 16:37:20 2010/02/21