HPE FlexNetwork HSR6800 series Configuration Manual page 133

[RouterA-GigabitEthernet3/0/1] quit
[RouterA] interface gigabitethernet 3/0/2
[RouterA-GigabitEthernet3/0/2] port link-type trunk
[RouterA-GigabitEthernet3/0/2] port trunk permit vlan 1 to 200
[RouterA-GigabitEthernet3/0/2] smart-link flush enable control-vlan 10 110
[RouterA-GigabitEthernet3/0/2] quit
5. Verify the configuration:
Use the display smart-link group command to display the smart link group configuration on a
device.
# Display the smart link group configuration on Router C.
[RouterC] display smart-link group all
Smart link group 1 information:
Device ID: 000f-e23d-5af0
Preemption delay: 1(s)
Preemption mode: ROLE
Control VLAN: 10
Protected VLAN: Reference Instance 1
Member
-----------------------------------------------------------------------------
GigabitEthernet3/0/1
GigabitEthernet3/0/2
Smart link group 2 information:
Device ID: 000f-e23d-5af0
Preemption mode: ROLE
Preemption delay: 1(s)
Control VLAN: 110
Protected VLAN: Reference Instance 2
Member
-----------------------------------------------------------------------------
GigabitEthernet3/0/2
GigabitEthernet3/0/1
Use the display smart-link flush command to display the flush messages received on a
device.
# Display the flush messages received on Router B.
[RouterB] display smart-link flush
Received flush packets
Receiving interface of the last flush packet
Receiving time of the last flush packet
Device ID of the last flush packet
Control VLAN of the last flush packet
Role State Flush-count Last-flush-time
MASTER ACTVIE 5
SLAVE STANDBY 1
Role State Flush-count Last-flush-time
MASTER ACTVIE 5
SLAVE STANDBY 1
126
16:37:20 2010/02/21
17:45:20 2010/02/21
16:37:20 2010/02/21
17:45:20 2010/02/21
: 5
: GigabitEthernet3/0/2
: 16:25:21 2010/02/21
: 000f-e23d-5af0
: 10