HPE FlexNetwork HSR6800 series Configuration Manual page 193

[RouterC-GigabitEthernet1/0/1] quit
# Create track entry 1 to associate with the physical status of GigabitEthernet 1/0/2 on Router C.
When the track entry becomes negative, it means that the interface fails.
[RouterC] track 1 interface gigabitethernet 1/0/2
# Configure VF tracking to monitor track entry 1 and specify the value by which the weight
decreases, making the weight of Router C decrease by more than 245 (250 in this example)
when track entry 1 turns to negative. In such a case, another router with a higher weight can
take over.
[RouterC] interface gigabitethernet 1/0/1
[RouterC-GigabitEthernet1/0/1] vrrp ipv6 vrid 1 weight track 1 reduced 250
4. Verify the configuration:
After the configuration, Host A can ping external networks successfully. To verify your
configuration, use the display vrrp ipv6 verbose command.
# Display the detailed information about VRRP group 1 on Router A.
[RouterA] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface GigabitEthernet1/0/1
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Member IP List : FE80::1 (Local, Master)
Forwarder Information: 3 Forwarders 1 Active
Config Weight
Running Weight : 255
Forwarder 01
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 02
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 03
State
Virtual MAC
Owner ID
: Load Balance
: Virtual MAC
: 1 Adver Timer
: Up State
: 120 Running Pri
: Yes Delay Time
: None
: FE80::10
1::10
FE80::2 (Backup)
FE80::3 (Backup)
: 255
: Active
: 000f-e2ff-4011 (Owner)
: 0000-5e01-1101
: 255
: local
: Listening
: 000f-e2ff-4012 (Learnt)
: 0000-5e01-1103
: 127
: FE80::2
: Listening
: 000f-e2ff-4013 (Learnt)
: 0000-5e01-1105
186
: 100
: Master
: 120
: 5