HPE FlexNetwork HSR6800 series Configuration Manual page 195

Run Mode
Run Method
Total number of virtual routers : 1
Interface GigabitEthernet1/0/1
VRID
Admin Status
Config Pri
Preempt Mode
Become Master
Auth Type
Virtual IP
Member IP List : FE80::3 (Local, Backup)
Forwarder Information: 3 Forwarders 1 Active
Config Weight
Running Weight : 255
Forwarder 01
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 02
State
Virtual MAC
Owner ID
Priority
Active
Forwarder 03
State
Virtual MAC
Owner ID
Priority
Active
Forwarder Weight Track Information:
Track Object
The output shows that in VRRP group 1, Router A is the master and Router B and Router C are
the backups. Each router has one AVF and two LVFs that act as the backups.
# When GigabitEthernet 1/0/2 on Router A fails, use the display vrrp ipv6 verbose command
to display the detailed information about VRRP group 1 on Router A.
[RouterA] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface GigabitEthernet1/0/1
VRID
: Load Balance
: Virtual MAC
: 1 Adver Timer
: Up State
: 100 Running Pri
: Yes Delay Time
: 4200ms left
: None
: FE80::10
1::10
FE80::1 (Master)
FE80::2 (Backup)
: 255
: Listening
: 000f-e2ff-4011 (Learnt)
: 0000-5e01-1101
: 127
: FE80::1
: Listening
: 000f-e2ff-4012 (Learnt)
: 0000-5e01-1103
: 127
: FE80::2
: Active
: 000f-e2ff-4013 (Owner)
: 0000-5e01-1105
: 255
: local
: 1 State : Positive
: Load Balance
: Virtual MAC
: 1 Adver Timer
188
: 100
: Backup
: 100
: 5
Weight Reduced : 250
: 100