Rpr Protection Mode/Static Ringlet Selection Configuration Example - HPE FlexNetwork HSR6800 series Configuration Manual

000f-e257-0003 Idle Idle 0
000f-e257-0004 Idle Idle 0
000f-e257-0005 Idle Idle 0
The topology information shows that the RPR ring is closed.
RPR protection mode/static ringlet selection configuration
example
Network requirements
As shown in
mode by default. Change the protection mode of the ring to wrapping. Configure a static ringlet
selection entry to allow frames from Station A to Station B to travel Ringlet 1 when no edge occurs on
the RPR ring (that is, the ring remains closed).
Figure 16 Network diagram
Configuration procedure
1. Configure the protection mode:
# Create RPR logical interface RPR 1 on Station A, and configure the protection mode as
wrapping on the interface.
<StationA> system-view
[StationA] interface rpr 1
[StationA-RPR1] rpr protect-mode wrap
Configure Station B through Station E in the same way Station A is configured. (Details not
shown.)
2. Configure static ringlet selection:
# On RPR logical interface RPR 1 of Station A, configure transmitting frames destined for
Station B through Ringlet 1.
[StationA-RPR1] rpr static-rs 000f-e257-0002 ringlet1
[StationA-RPR1] quit
3. Verify the configuration:
# Display ring topology information on Station A.
[StationA] display rpr topology ring
Ring-level topology information on interface: RPR1
Stations on ringlet0: 4
Stations on ringlet1: 4
Figure 16, Stations A through E form an RPR ring and operate in steering protection
0 0 0 0.0.0.0
0 0 0 0.0.0.0
0 0 0 0.0.0.0
68