Configuring Rrpp Nodes - HPE FlexNetwork HSR6800 series Configuration Manual

•
RRPP ports always allow packets from the control VLANs to pass through.
•
For more information about the port link-type trunk, port trunk permit vlan, and undo stp
enable commands, see Layer 2—LAN Switching Command Reference.
•
Do not enable OAM remote loopback function on an RRPP port. Otherwise, it might cause
temporary broadcast storms.
•
Hewlett Packard Enterprise recommends using the link-delay command to enable link status
rapid report function on an RRPP port by setting the physical state change suppression interval
to 0 seconds, accelerating topology convergence. For more information about the link-delay
command (or the undo link-delay command), see Interface Command Reference.
To configure RRPP ports:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the link type of the
interface as trunk.
4. Assign the trunk port to the
protected VLANs of the
RRPP domain.
5. Disable the spanning tree
feature.

Configuring RRPP nodes

The maximum number of rings that can be configured on a device in all RRPP domains is 16.
If a device carries multiple RRPP rings in an RRPP domain, only one ring can be configured as the
primary ring on the device and the role of the device on a subring can only be an edge node or an
assistant-edge node.
Specifying a master node
Perform this configuration on a device to be configured as a master node.
To specify a master node:
Step
1. Enter system view.
2. Enter RRPP domain view.
3. Specify the current device as the
master node of the ring, and specify the
primary port and the secondary port.
Specifying a transit node
Perform this configuration on a device to be configured as a transit node.
To specify a transit node:
Step
1. Enter system view.
2. Enter RRPP domain view.
Command
system-view
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
undo stp enable
Command
system-view
rrpp domain domain-id
ring ring-id node-mode master [ primary-port
interface-type interface-number ] [ secondary-port
interface-type interface-number ] level level-value
Command
system-view
rrpp domain domain-id
81
Remarks
N/A
N/A
Access by default.
By default, a trunk port allows only packets
from VLAN 1 to pass through.
Enabled by default.