HPE FlexNetwork HSR6800 series Configuration Manual page 225

# Create VRRP group 1, and configure the virtual IP address of the group as 192.168.0.10.
Configure the priority of Router A in VRRP group 1 as 110, and configure VRRP group 1 to
monitor the status of track entry 1. When the status of the track entry becomes Negative, the
priority of Router A decreases by 20.
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] vrrp vrid 1 virtual-ip 192.168.0.10
[RouterA-GigabitEthernet1/0/2] vrrp vrid 1 priority 110
[RouterA-GigabitEthernet1/0/2] vrrp vrid 1 track 1 reduced 20
[RouterA-GigabitEthernet1/0/2] return
4. Configure VRRP on Router B:
# Create VRRP group 1, and configure the virtual IP address of the group as 192.168.0.10.
<RouterB> system-view
[RouterB] interface gigabitethernet 1/0/2
[RouterB-GigabitEthernet1/0/2] vrrp vrid 1 virtual-ip 192.168.0.10
[RouterB-GigabitEthernet1/0/2] return
Verifying the configuration
# Display detailed information about the VRRP group on Router A.
<RouterA> display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface GigabitEthernet1/0/2
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
VRRP Track Information:
Track Object
# Display information about track entry 1 on Router A.
<RouterA> display track 1
Track ID: 1
Status: Positive
Duration: 0 days 0 hours 2 minutes 11 seconds
Notification delay: Positive 0, Negative 0 (in seconds)
Reference object:
BFD session:
Packet type: Echo
Interface
Remote IP
Local IP
# Display detailed information about the VRRP group on Router B.
<RouterB> display vrrp verbose
IPv4 Standby Information:
: Standard
: Virtual MAC
: 1
: Up
: 110
: Yes
: None
: 192.168.0.10
: 0000-5e00-0101
: 192.168.0.101
: 1
: GigabitEthernet1/0/1
: 1.1.1.2
: 1.1.1.1
Adver Timer : 1
State : Master
Running Pri : 110
Delay Time : 0
State : Positive
218
Pri Reduced : 20