Dell S6100 Configuration Manual page 919

Hide thumbs Also See for S6100:

Table of Contents

Figure 133. Example of VLT Deployment

VLT offers the following benefits:

Allows a single device to use a LAG across two upstream devices.

Eliminates STP-blocked ports.

Provides a loop-free topology.

Uses all available uplink bandwidth.

Provides fast convergence if either the link or a device fails.

Optimized forwarding with virtual router redundancy protocol (VRRP).

Provides link-level resiliency.

Assures high availability.

Active-Active load sharing with VRRP.

Active-Active load sharing with peer-routing for Layer-3 VLAN

Graceful failover of LACP during reload

Agility in VM Migration under VLT domain.

Dell Networking does not recommend enabling Stacking and VLT simultaneously. If you enable both features at the

same time, unexpected behavior may occur.

As shown in the following example, VLT presents a single logical Layer 2 domain from the perspective of attached devices that have a

virtual link trunk terminating on separate chassis in the VLT domain. However, the two VLT chassis are independent Layer2/Layer3 (L2/L3)

switches for devices in the upstream network. L2/L3 control plane protocols and system management features function normally in VLT

mode. Features such as VRRP and internet group management protocol (IGMP) snooping require state information coordinating between

the two VLT chassis. IGMP and VLT configurations must be identical on both sides of the trunk to ensure the same behavior on both sides.

The following example shows how VLT is deployed. The switches appear as a single virtual switch from the point of view of the switch or

server supporting link aggregation control protocol (LACP).

Virtual Link Trunking (VLT)

Troubleshooting