Enabling Snmp Traps For Root Elections And Topology Changes; Configuring Spanning Trees As Hitless - Dell S6100 Configuration Manual

• Spanning Tree Protocol (STP)
• Rapid Spanning Tree Protocol (RSTP)
• Multiple Spanning Tree Protocol (MSTP)
• Per-VLAN Spanning Tree Plus (PVST+)
• When enabled on a port, root guard applies to all VLANs configured on the port.
• You cannot enable root guard and loop guard at the same time on an STP port. For example, if you configure root guard on a port on
which loop guard is already configured, the following error message displays: • % Error: LoopGuard is configured.
Cannot configure RootGuard.
• When used in an MSTP network, if root guard blocks a boundary port in the CIST, the port is also blocked in all other MST instances.
To enable the root guard on an STP-enabled port or port-channel interface in instance 0, use the following command.
• Enable root guard on a port or port-channel interface.
INTERFACE mode or INTERFACE PORT-CHANNEL mode
spanning-tree {0 | mstp | rstp | pvst} rootguard
• 0: enables root guard on an STP-enabled port assigned to instance 0.
• mstp: enables root guard on an MSTP-enabled port.
• rstp: enables root guard on an RSTP-enabled port.
• pvst: enables root guard on a PVST-enabled port.
To disable STP root guard on a port or port-channel interface, use the no spanning-tree 0 rootguard command in an interface
configuration mode.
To verify the STP root guard configuration on a port or port-channel interface, use the show spanning-tree 0 guard
[interface interface] command in a global configuration mode.
Enabling SNMP Traps for Root Elections and Topology
Changes
To enable SNMP traps individually or collectively, use the following commands.
• Enable SNMP traps for spanning tree state changes.
snmp-server enable traps stp
• Enable SNMP traps for RSTP, MSTP, and PVST+ collectively.
snmp-server enable traps xstp

Configuring Spanning Trees as Hitless

You can configure STP, RSTP, MSTP, and PVST+ to be hitless (configure all or none as hitless). When configured as hitless, critical protocol
state information is synchronized between the RPMs so that RPM failover is seamless and no topology change is triggered.
To be hitless per spanning tree type or for all spanning tree types, use the following commands.
• Configure LACP to be hitless.
CONFIGURATION mode
redundancy protocol lacp
• Configure all spanning tree types to be hitless.
CONFIGURATION mode
redundancy protocol xstp
Spanning Tree Protocol (STP) 875