Dell S6100 Configuration Manual page 279

6
7
Priority# Bandwidth TSA
0
1
2
3
4
5
6
7
Remote Parameters:
-------------------
Remote is disabled
Local Parameters :
------------------
Local is enabled
TC-grp Priority#
0 0,1,2,3,4,5,6,7
1
2
3
4
5
6
7
Priority#
0
1
2
3
4
5
6
7
Oper status is init
Conf TLV Tx Status is disabled
Traffic Class TLV Tx Status is disabled
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
0 Input Traffic Class TLV Pkts, 0 Output Traffic Class TLV Pkts, 0 Error Traffic Class TLV Pkts
The following table describes the show interface ets detail command fields.
Table 22. show interface ets detail Command Description
Field
Interface
Maximum Supported
Number of Traffic Classes
Admin mode
Admin Parameters
Remote Parameters
0% ETS
0% ETS
13% ETS
13% ETS
13% ETS
13% ETS
12% ETS
12% ETS
12% ETS
12% ETS
Bandwidth TSA
100% ETS
0% ETS
0% ETS
0% ETS
0% ETS
0% ETS
0% ETS
0% ETS
Bandwidth TSA
13% ETS
13% ETS
13% ETS
13% ETS
12% ETS
12% ETS
12% ETS
12% ETS
Description
Interface type with and port number.
Maximum number of priority groups supported.
Number of 802.1p priorities currently configured.
ETS mode: on or off.
ETS configuration on local port, including priority groups, assigned
dot1p priorities, and bandwidth allocation.
ETS configuration on remote peer port, including Admin mode
(enabled if a valid TLV was received or disabled), priority groups,
assigned dot1p priorities, and bandwidth allocation. If the ETS
Admin mode is enabled on the remote port for DCBx exchange, the
Willing bit received in ETS TLVs from the remote peer is included.
Data Center Bridging (DCB) 279