Dell S6100 Configuration Manual page 732

• map-name: the name of a configured route map.
To view the current RIP configuration, use the show running-config command in EXEC mode or the show config command in
ROUTER RIP mode.
Setting the Send and Receive Version
To change the RIP version globally or on an interface in Dell Networking OS, use the following command.
To specify the RIP version, use the version command in ROUTER RIP mode. To set an interface to receive only one or the other version,
use the ip rip send version or the ip rip receive version commands in INTERFACE mode.
You can set one RIP version globally on the system using system. This command sets the RIP version for RIP traffic on the interfaces
participating in RIP unless the interface was specifically configured for a specific RIP version.
• Set the RIP version sent and received on the system.
ROUTER RIP mode
version {1 | 2}
• Set the RIP versions received on that interface.
INTERFACE mode
ip rip receive version [1] [2]
• Set the RIP versions sent out on that interface.
INTERFACE mode
ip rip send version [1] [2]
Examples of the RIP Process
To see whether the version command is configured, use the show config command in ROUTER RIP mode.
The following example shows the RIP configuration after the ROUTER RIP mode version command is set to RIPv2. When you set the
ROUTER RIP mode version command, the interface () participating in the RIP process is also set to send and receive RIPv2 (shown
in bold).
To view the routing protocols configuration, use the show ip protocols command in EXEC mode.
To configure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax. The command syntax for sending
both RIPv1 and RIPv2 and receiving only RIPv2 is shown in the following example.
Dell(conf-if)#ip rip send version 1 2
Dell(conf-if)#ip rip receive version 2
The following example of the show ip protocols command confirms that both versions are sent out that interface. This interface no
longer sends and receives the same RIP versions as Dell Networking OS does globally (shown in bold).
Generating a Default Route
Traffic is forwarded to the default route when the traffic's network is not explicitly listed in the routing table.
Default routes are not enabled in RIP unless specified. Use the default-information originate command in ROUTER RIP mode
to generate a default route into RIP. In Dell Networking OS, default routes received in RIP updates from other routes are advertised if you
configure the default-information originate command.
• Specify the generation of a default route in RIP.
ROUTER RIP mode
default-information originate [always] [metric value] [route-map route-map-name]
732 Routing Information Protocol (RIP)