Dell S6100 Configuration Manual page 447

Hide thumbs Also See for S6100:

Table of Contents

managed-config-flag {on | off}

Enable verification of the sender IPv6 address in inspected messages from the authorized device source access list.

POLICY LIST CONFIGURATION mode

match ra{ipv6-access-list name | ipv6-prefix-list name | mac-access-list name}

Enable verification of the advertised other configuration parameter.

POLICY LIST CONFIGURATION mode

other-config-flag {on | off}

Enable verification of the advertised default router preference value. The preference value must be less than or equal to the specified

POLICY LIST CONFIGURATION mode

router-preference maximum {high | low | medium}

Set the router lifetime.

POLICY LIST CONFIGURATION mode

router—lifetime value

The router lifetime range is from 0 to 9,000 seconds.

Apply the policy to trusted ports.

POLICY LIST CONFIGURATION mode

trusted-port

Set the maximum transmission unit (MTU) value.

POLICY LIST CONFIGURATION mode

Set the advertised reachability time.

POLICY LIST CONFIGURATION mode

reachable—time value

The reachability time range is from 0 to 3,600,000 milliseconds.

Set the advertised retransmission time.

POLICY LIST CONFIGURATION mode

retrans—timer value

The retransmission time range is from 100 to 4,294,967,295 milliseconds.

Display the configurations applied on the RA guard policy mode.

POLICY LIST CONFIGURATION mode

Example of the show config Command

Dell(conf-ra_guard_policy_list)#show config

ipv6 nd ra-guard policy test

device-role router

hop-limit maximum 251

other-config-flag on

IPv6 Routing

Troubleshooting