Configuring Lossless Queues - Dell S6100 Configuration Manual

NOTE: You cannot enable PFC and link-level flow control at the same time on an
interface.

Configuring Lossless Queues

DCB also supports the manual configuration of lossless queues on an interface when PFC mode is turned off.
Prerequisite: A DCB with PFC configuration is applied to the interface with the following conditions:
• PFC mode is off (no pfc mode on).
• No PFC priority classes are configured (no pfc priority priority-range).
Example:
Port A —> Port B
Port C —> Port B
PFC no-drop queues are configured for queues 3, 4 on Port B. PFC capability is enabled on priorities 3, 4 on PORT A and C.
Port B acting as Egress
During the congestion, [traffic pump on priorities 3 and 4 from PORT A and PORT C is at full line rate], PORT A and C send out the PFCs
to rate the traffic limit. Egress drops are not observed on Port B since traffic flow on priorities is mapped to loss less queues.
Port B acting as Ingress
If the traffic congestion is on PORT B , Egress DROP is on PORT A or C, as the PFC is not enabled on PORT B.
Refer the following configuration for queue to dot1p mapping:
The configuration of no-drop queues provides flexibility for ports on which PFC is not needed but lossless traffic should egress from the
interface.
Lossless traffic egresses out the no-drop queues. Ingress dot1p traffic from PFC-enabled interfaces is automatically mapped to the no-drop
egress queues.
1 Enter INTERFACE Configuration mode.
CONFIGURATION mode
interface type slot/port
2 Configure the port queues that will still function as no-drop queues for lossless traffic.
INTERFACE mode
pfc no-drop queues queue-range
For the dot1p-queue assignments, refer to the dot1p Priority-Queue Assignment table.
The maximum number of lossless queues globally supported on the switch is two.
The default: No lossless queues are configured.
3 Configure to drop the unknown unicast packets flooding on lossless priorities.
CONFIGURATION mode
pfc-nodrop-priority l2-dlf drop
4 View the packets drop count corresponding to the priority.
EXEC mode
EXEC Privilege mode
Data Center Bridging (DCB) 253