Dell S6100 Configuration Manual page 471
Hide thumbs
Also See for S6100:
- Configuration manual (1743 pages) ,
- Installation manual (54 pages) ,
- Release notes (13 pages)
Table of Contents
Advertisement
•
For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the stack/slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
•
For a port channel interface, enter the keywords port-channel then a number.
•
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Distribute Routes
Another method of controlling routing information is to filter the information through a prefix list.
Prefix lists are applied to incoming or outgoing routes and routes must meet the conditions of the prefix lists or Dell Networking OS does
not install the route in the routing table. The prefix lists are globally applied on all interfaces running IS-IS.
Configure the prefix list in PREFIX LIST mode prior to assigning it to the IS-IS process. For configuration information on prefix lists, refer to
Access Control Lists
(ACLs).
Applying IPv4 Routes
To apply prefix lists to incoming or outgoing IPv4 routes, use the following commands.
NOTE:
These commands apply to IPv4 IS-IS only. To apply prefix lists to IPv6 routes, use ADDRESS-FAMILY IPV6 mode, shown
later.
•
Apply a configured prefix list to all incoming IPv4 IS-IS routes.
ROUTER ISIS mode
distribute-list prefix-list-name in [interface]
Enter the type of interface and the interface information:
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the stack/slot/port/subport information.
•
For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the stack/slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.
•
For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.
•
For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the stack/slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
•
For a port channel interface, enter the keywords port-channel then a number.
•
For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
•
Apply a configured prefix list to all outgoing IPv4 IS-IS routes.
ROUTER ISIS mode
distribute-list prefix-list-name out [bgp as-number | connected | ospf process-id | rip |
static]
You can configure one of the optional parameters:
•
connected: for directly connected routes.
•
ospf process-id: for OSPF routes only.
•
rip: for RIP routes only.
•
static: for user-configured routes.
•
bgp: for BGP routes only.
•
Deny RTM download for pre-existing redistributed IPv4 routes.
ROUTER ISIS mode
distribute-list redistributed-override in
Intermediate System to Intermediate System
471
Advertisement
Table of Contents
Troubleshooting
