Enable Vlan-Stacking For A Vlan; Configuring The Protocol Type Value For The Outer Vlan Tag; Configuring Dell Networking Os Options For Trunk Ports - Dell S6100 Configuration Manual

Hide thumbs Also See for S6100:

Table of Contents

Enable VLAN-Stacking for a VLAN

To enable VLAN-Stacking for a VLAN, use the following command.

Enable VLAN-Stacking for the VLAN.

INTERFACE VLAN mode

vlan-stack compatible

Example of Viewing VLAN Stack Member Status

To display the status and members of a VLAN, use the show vlan command from EXEC Privilege mode. Members of a VLAN-Stacking-

enabled VLAN are marked with an M in column Q.

The tag protocol identifier (TPID) field of the S-Tag is user-configurable.

To set the S-Tag TPID, use the following command.

Select a value for the S-Tag TPID.

CONFIGURATION mode

vlan-stack protocol-type

The default is 9100.

To display the S-Tag TPID for a VLAN, use the show running-config command from EXEC privilege mode. Dell Networking OS

displays the S-Tag TPID only if it is a non-default value.

802.1ad trunk ports may also be tagged members of a VLAN so that it can carry single and double-tagged traffic.

You can enable trunk ports to carry untagged, single-tagged, and double-tagged VLAN traffic by making the trunk port a hybrid port.

To configure trunk ports, use the following commands.

Configure a trunk port to carry untagged, single-tagged, and double-tagged traffic by making it a hybrid port.

INTERFACE mode

portmode hybrid

Add the port to a 802.1Q VLAN as tagged or untagged.

INTERFACE VLAN mode

[tagged | untagged]

Example of Configuring a Trunk Port as a Hybrid Port and Adding it to Stacked VLANs

In the following example, TenGigabitEthernet 1/1/1/1 is a trunk port that is configured as a hybrid port and then added to VLAN

100 as untagged VLAN 101 as tagged, and VLAN 103, which is a stacking VLAN.

Dell(conf)#interface tenigabitethernet 1/1/1/1

Dell(conf-if-te-1/1/1/1)#portmode hybrid

Dell(conf-if-te-1/1/1/1)#switchport

Dell(conf-if-te-1/1/1/1)#vlan-stack trunk

Dell(conf-if-te-1/1/1/1)#show config

Service Provider Bridging