Dell S6100 Configuration Manual page 232

The following additional CAM allocation settings are supported.
Table 11. Additional Default CAM Allocation Settings
Additional CAM Allocation
FCoE ACL (fcoeacl)
ISCSI Opt ACL (iscsioptacl)
You must enter l2acl, ipv4acl, l2qos, l2pt, ipv4qos, ipv4pbr, vrfv4acl, and fcoe allocations as a factor of 2, ipv6acl,
openflow, and vman_qos allocations as a factor of 3. Ipv4 acl region should also be in multiples of 3 when ipv4udf option is
enabled. All other profile allocations can use either even or odd numbered ranges.
NOTE: You can only have one odd number of blocks in the CLI configuration; the other blocks must be in factors of 2. For
example, a CLI configuration of 5+4+2+1+1 blocks is not supported; a configuration of 6+4+2+1 blocks is supported.
For the new settings to take effect, you must save the new CAM settings to the startup-config (write-mem or copy run start)
then reload the system for the new settings to take effect.
CAM Allocation for Egress
To allocate the space for egress L2, IPV4, and IPV6 ACL, use the cam-acl-egress command. The total number of available FP blocks is
4. Allocate at least one group of L2ACL and IPV4 ACL.
Dell(conf)#do show cam-acl-egress
-- Chassis Egress Cam ACL --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
-- Stack unit 0 --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
-- Stack unit 7 --
Current Settings(in block sizes)
L2Acl :
Ipv4Acl :
Ipv6Acl :
Dell(conf)#
1 Select a cam-acl action.
CONFIGURATION mode
cam-acl [default | l2acl]
NOTE: Selecting default resets the CAM entries to the default settings. Select l2acl to allocate the desired space
for all other regions.
2 Enter the number of FP blocks for each region.
EXEC Privilege mode
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number l2qos number
l2pt number ipmacacl number vman-qos | vman-dual-qos number nlbcluster number ipv4pbr number
openflow number | fcoe number [vrfv4acl number]
232 Content Addressable Memory (CAM)
1 block = 256 entries
1
1
2
1
1
2
1
1
2
Setting
0
0