Dell S6100 Configuration Manual page 702

Use Step 1 or Step 2 to start creating a Layer 2 class map.
1 Create a match-any class map.
CONFIGURATION mode
class-map match-any
2 Create a match-all class map.
CONFIGURATION mode
class-map match-all
3 Specify your match criteria.
CLASS MAP mode
match mac
After you create a class-map, Dell Networking OS places you in CLASS MAP mode.
Match-any class maps allow up to five access-lists. Match-all class-maps allow only one. You can match against only one VLAN ID.
4 Link the class-map to a queue.
POLICY MAP mode
service-queue
Determining the Order in Which ACLs are Used to Classify Traffic
When you link class-maps to queues using the service-queue command, Dell Networking OS matches the class-maps according to
queue priority (queue numbers closer to 0 have lower priorities).
For example, as described in the previous example, class-map cmap2 is matched against ingress packets before cmap1.
ACLs acl1 and acl2 have overlapping rules because the address range 20.1.1.0/24 is within 20.0.0.0/8. Therefore (without the keyword
order), packets within the range 20.1.1.0/24 match positive against cmap1 and are buffered in queue 7, though you intended for these
packets to match positive against cmap2 and be buffered in queue 4.
In cases such as these, where class-maps with overlapping ACL rules are applied to different queues, use the keyword order. Dell
Networking OS writes to the CAM ACL rules with lower order numbers (order numbers closer to 0) before rules with higher order numbers
so that packets are matched as you intended.
• Specify the order in which you want to apply ACL rules using the keyword order.
order
The order can range from 0 to 254.
By default, all ACL rules have an order of 255.
Displaying Configured Class Maps and Match Criteria
To display all class-maps or a specific class map, use the following command.
Dell Networking OS Behavior: An explicit "deny any" rule in a Layer 3 ACL used in a (match any or match all) class-map creates a "default
to Queue 0" entry in the CAM, which causes unintended traffic classification. In the following example, traffic is classified in two Queues, 1
and 2. Class-map ClassAF1 is "match any," and ClassAF2 is "match all".
• Display all class-maps or a specific class map.
EXEC Privilege mode
show qos class-map
702 Quality of Service (QoS)