Dell S6100 Configuration Manual page 711

Hide thumbs Also See for S6100:

Table of Contents

Applying an Input Policy Map to an Interface

To apply an input policy map to an interface, use the following command.

You can apply the same policy map to multiple interfaces, and you can modify a policy map after you apply it.

You cannot apply a class-map and QoS policies to the same interface.

You cannot apply an input Layer 2 QoS policy on an interface you also configure with vlan-stack access.

If you apply a service policy that contains an ACL to more than one interface, Dell Networking OS uses ACL optimization to conserve

CAM space. The ACL optimization behavior detects when an ACL exists in the CAM rather than writing it to the CAM multiple times.

Apply an input policy map to an interface.

INTERFACE mode

service-policy input

Specify the keyword layer2 if the policy map you are applying a Layer 2 policy map.

Creating Output Policy Maps

Create an output policy map.

CONFIGURATION mode

policy-map-output

After you create an output policy map, do one or more of the following:

Applying an Output QoS Policy to a Queue

Specifying an Aggregate QoS Policy

Applying an Output Policy Map to an Interface

Apply the policy map to an interface.

Applying an Output QoS Policy to a Queue

To apply an output QoS policy to a queue, use the following command.

Apply an output QoS policy to queues.

INTERFACE mode

service-queue

Specifying an Aggregate QoS Policy

To specify an aggregate QoS policy, use the following command.

Specify an aggregate QoS policy.

POLICY-MAP-OUT mode

policy-aggregate

Quality of Service (QoS)

Troubleshooting