Enabling A Subset Of Snmp Traps - Dell S6100 Configuration Manual

• Dell Networking enterpriseSpecific environment traps — fan, supply, and temperature.
• Dell Networking enterpriseSpecific protocol traps — bgp, ecfm, stp, and xstp.
To configure the system to send SNMP notifications, use the following commands.
1 Configure the Dell Networking system to send notifications to an SNMP server.
CONFIGURATION mode
snmp-server host ip-address [traps | informs] [version 1 | 2c |3] [community-string]
To send trap messages, enter the keyword traps.
To send informational messages, enter the keyword informs.
To send the SNMP version to use for notification messages, enter the keyword version.
To identify the SNMPv1 community string, enter the name of the community-string.
2 Specify which traps the Dell Networking system sends to the trap receiver.
CONFIGURATION mode
snmp-server enable traps
Enable all Dell Networking enterprise-specific and RFC-defined traps using the snmp-server enable traps command from
CONFIGURATION mode.
Enable all of the RFC-defined traps using the snmp-server enable traps snmp command from CONFIGURATION mode.
3 Specify the interfaces out of which Dell Networking OS sends SNMP traps.
CONFIGURATION mode
snmp-server trap-source
Example of RFC-Defined SNMP Traps and Related Enable Commands
The following example lists the RFC-defined SNMP traps and the command used to enable each. The coldStart and warmStart traps are
enabled using a single command.
snmp authentication
string.
snmp coldstart
snmp linkdown
snmp linkup

Enabling a Subset of SNMP Traps

You can enable a subset of Dell Networking enterprise-specific SNMP traps using one of the following listed command options.
To enable a subset of Dell Networking enterprise-specific SNMP traps, use the following command.
• Enable a subset of SNMP traps.
snmp-server enable traps
NOTE: The envmon option enables all environment traps including those traps that are enabled with the envmon
supply, envmon temperature, and envmon fan options.
SNMP_AUTH_FAIL:SNMP Authentication failed.Request with invalid community
SNMP_COLD_START: Agent Initialized - SNMP COLD_START.
SNMP_WARM_START:Agent Initialized - SNMP WARM_START.
PORT_LINKDN:changed interface state to down:%d
PORT_LINKUP:changed interface state to up:%d
Simple Network Management Protocol (SNMP) 827