Dell S6100 Configuration Manual page 39

CLI Command Mode
ROUTER OSPFV3
ROUTER RIP
SPANNING TREE
TRACE-LIST
CLASS-MAP
CONTROL-PLANE
DHCP
DHCP POOL
ECMP
EIS
FRRP
LLDP
LLDP MANAGEMENT INTERFACE
LINE
MONITOR SESSION
OPENFLOW INSTANCE
PORT-CHANNEL FAILOVER-GROUP
PRIORITY GROUP
PROTOCOL GVRP
QOS POLICY
SUPPORTASSIST
VLT DOMAIN
VRRP
UPLINK STATE GROUP
The following example shows how to change the command mode from CONFIGURATION mode to PROTOCOL SPANNING TREE.
Example of Changing Command Modes
Dell(conf)#protocol spanning-tree 0
Dell(config-span)#
Prompt
Dell(conf-ipv6router_ospf)#
Dell(conf-router_rip)#
Dell(config-span)#
Dell(conf-trace-acl)#
Dell(config-class-map)#
Dell(conf-control-cpuqos)#
Dell(config-dhcp)#
Dell(config-dhcp-pool-name)#
Dell(conf-ecmp-group-ecmp-
group-id)#
Dell(conf-mgmt-eis)#
Dell(conf-frrp-ring-id)#
Dell(conf-lldp)# or Dell(conf-if
—interface-lldp)#
Dell(conf-lldp-mgmtIf)#
Dell(config-line-console) or
Dell(config-line-vty)
Dell(conf-mon-sess-sessionID)#
Dell(conf-of-instance-of-id)#
Dell(conf-po-failover-grp)#
Dell(conf-pg)#
Dell(config-gvrp)#
Dell(conf-qos-policy-out-ets)#
Dell(support-assist)#
Dell(conf-vlt-domain)#
Dell(conf-if-interface-type-
slot/port-vrid-vrrp-group-id)#
Dell(conf-uplink-state-group-
groupID)#
Access Command
ipv6 router ospf
router rip
protocol spanning-tree 0
ip trace-list
class-map
control-plane-cpuqos
ip dhcp server
pool (DHCP Mode)
ecmp-group
management egress-interface-
selection
protocol frrp
protocol lldp (CONFIGURATION or
INTERFACE Modes)
management-interface (LLDP Mode)
line console orline vty
monitor session
openflow of-instance
port-channel failover-group
priority-group
protocol gvrp
qos-policy-output
support-assist
vlt domain
vrrp-group
uplink-state-group
Configuration Fundamentals 39