Two Factor Authentication (2Fa); Handling Access-Challenge Message; Configuring Challenge Response Authentication For Sshv2 - Dell S6100 Configuration Manual

0 console 0 admin
*3 vty 1 sec1
4 vty 2 ml1

Two Factor Authentication (2FA)

Two factor authentication also known as 2FA, strengthens the login security by providing one time password (OTP) in addition to username
and password. 2FA supports RADIUS authentications with Console, Telnet, and SSHv2.
To perform 2FA, follow these steps:
• When the Network access server (NAS) prompts for the username and password, provide the inputs.
• If the credentials are valid:
• RADIUS server sends a request to the SMS–OTP daemon to generate an OTP for the user.
• A challenge authentication is sent from the RADIUS server as Reply–Message attribute.
• If the Reply–Message attribute is not sent from the RADIUS server, the default text is the Response.
• 2FA is successful only on providing the correct OTP.
• If the credentials are invalid, the authentication fails.
NOTE: 2FA does not support RADIUS authentications done with SSHv1, REST, Web UI, and OMI.

Handling Access-Challenge Message

To provide a two-step verification in addition to the username and password, NAS prompts for additional information. An Access-Challenge
request is sent from the RADIUS server to NAS.
The RADIUS server returns one of the following responses:
• Access-Challenge—If the user credentials are valid, the NAS server receives an Access-Challenge request from the RADIUS server.
• Access-Accept—NAS validates the username and password. If the credentials are valid, the RADIUS server sends an Access-Request
to the short message service one time password (SMS-OTP) daemon to generate an OTP. The OTP is sent to the user's e-mail ID or
mobile. If the OTP is valid, the RADIUS server authenticates the 2FA user and sends an Access-Accept response to NAS.
• Access-Reject—NAS validates the OTP and if the OTP is invalid, the RADIUS server does not authenticate the user and sends an
Access-Reject response to NAS.

Configuring Challenge Response Authentication for SSHv2

To configure challenge response authentication for SSHv2, perform the following steps:
1 Enable challenge response authentication for SSHv2.
CONFIGURATION mode
ip ssh challenge-response-authentication enable
2 View the configuration.
EXEC mode
show ip ssh
Dell# show ip ssh
SSH server
SSH server version
SSH server vrf
SSH server ciphers
cbc,3des-cbc.
792 Security
sysadmin 15
secadmin 14
netadmin 12
: enabled.
: v1 and v2.
: default.
: aes256-ctr,aes256-cbc,aes192-ctr,aes192-cbc,aes128-ctr,aes128-
idle
idle 172.31.1.4
idle 172.31.1.5