Dell S6100 Configuration Manual page 736

Destination Gateway
----------- ------- ----------- -----------
C 10.11.10.0/24
C 10.11.20.0/24
R 10.11.30.0/24
C 10.200.10.0/24
C 10.300.10.0/24
R 192.168.1.0/24
R 192.168.2.0/24
Core2#
R 192.168.1.0/24
R 192.168.2.0/24
Core2#
The following example shows the show ip protocols command to show the RIP configuration activity on Core 2.
Core2#show ip protocols
Routing Protocol is "RIP"
Sending updates every 30 seconds, next due in 17
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control: receive version 2, send version 2
Interface Recv Send
TenGigabitEthernet 1/1/1/1
TenGigabitEthernet 1/1/1/2
TenGigabitEthernet 1/1/1/3
TenGigabitEthernet 1/1/1/4 2 2
Routing for Networks:
10.300.10.0
10.200.10.0
10.11.20.0
10.11.10.0
Routing Information Sources:
Gateway Distance
10.11.20.1 120
Distance: (default is 120)
Core2#
RIP Configuration on Core3
The following example shows how to configure RIPv2 on a host named Core3.
Example of Configuring RIPv2 on Core3
Core3(conf)#router rip
Core3(conf-router_rip)#version 2
Core3(conf-router_rip)#network 192.168.1.0
Core3(conf-router_rip)#network 192.168.2.0
Core3(conf-router_rip)#network 10.11.30.0
Core3(conf-router_rip)#network 10.11.20.0
Core3(conf-router_rip)#show config
!
router rip
network 10.0.0.0
network 192.168.1.0
network 192.168.2.0
version 2
Core3(conf-router_rip)#
736 Routing Information Protocol (RIP)
Dist/Metric Last Change
Direct, Te 2/11/1
Direct, Te 2/3/1
via 10.11.20.1, Te 1/1/1/1
Direct, Te 2/4/1
Direct, Te 2/5/1
via 10.11.20.1, Te 1/1/1/1
via 10.11.20.1, Te 1/1/1/1
via 10.11.20.1, Te 1/1/1/1
via 10.11.20.1, Te 1/1/1/1
2 2
2 2
2 2
Last Update
00:00:12
0/0 00:02:26
0/0 00:02:02
120/1 00:01:20
0/0 00:03:03
0/0 00:02:42
120/1 00:01:20
120/1 00:01:20
120/1 00:05:22
120/1 00:05:22