Dell S6100 Configuration Manual page 465

Use this command for IPv6 route computation only when you enable multi-topology. If using single-topology mode, to apply to both
IPv4 and IPv6 route computations, use the spf-interval command in CONFIG ROUTER ISIS mode.
4 Implement a wide metric-style globally.
ROUTER ISIS AF IPV6 mode
isis ipv6 metric metric-value [level-1 | level-2 | level-1-2]
To configure wide or wide transition metric style, the cost can be between 0 and 16,777,215.
Configuring IS-IS Graceful Restart
To enable IS-IS graceful restart globally, use the following commands. Additionally, you can implement optional commands to enable the
graceful restart settings.
• Enable graceful restart on ISIS processes.
ROUTER-ISIS mode
graceful-restart ietf
• Configure the time during which the graceful restart attempt is prevented.
ROUTER-ISIS mode
graceful-restart interval minutes
The range is from 1 to 120 minutes.
The default is 5 minutes.
• Enable the graceful restart maximum wait time before a restarting peer comes up.
ROUTER-ISIS mode
graceful-restart restart-wait seconds
When implementing this command, be sure to set the t3 timer to adjacency on the restarting router.
The range is from 1 to 120 minutes.
The default is 30 seconds.
• Configure the time that the graceful restart timer T1 defines for a restarting router to use for each interface, as an interval before
regenerating Restart Request (an IIH with RR bit set in Restart TLV) after waiting for an acknowledgement.
ROUTER-ISIS mode
graceful-restart t1 {interval seconds | retry-times value}
• interval: wait time (the range is from 5 to 120. The default is 5.)
• retry-times: number of times an unacknowledged restart request is sent before the restarting router gives up the graceful
restart engagement with the neighbor. (The range is from 1 to 10 attempts. The default is 1.)
• Configure the time for the graceful restart timer T2 that a restarting router uses as the wait time for each database to synchronize.
ROUTER-ISIS mode
graceful-restart t2 {level-1 | level-2} seconds
• level-1, level-2: identifies the database instance type to which the wait interval applies.
The range is from 5 to 120 seconds.
The default is 30 seconds.
• Configure graceful restart timer T3 to set the time used by the restarting router as an overall maximum time to wait for database
synchronization to complete.
Intermediate System to Intermediate System 465