Displaying Remote-Port Mirroring Configurations - Dell S6100 Configuration Manual

Restrictions
When you configure remote port mirroring, the following restrictions apply:
• You can configure the same source port to be used in multiple source sessions.
• You cannot configure a source port channel or source VLAN in a source session if the port channel or VLAN has a member port that is
configured as a destination port in a remote-port mirroring session.
• A destination port for remote port mirroring cannot be used as a source port, including the session in which the port functions as the
destination port.
• A destination port cannot be used in any spanning tree instance.
• The reserved VLAN used to transport mirrored traffic must be a L2 VLAN. L3 VLANs are not supported.
• On a source switch on which you configure source ports for remote port mirroring, you can add only one port to the dedicated RPM
VLAN which is used to transport mirrored traffic. You can configure multiple ports for the dedicated RPM VLAN on intermediate and
destination switches.

Displaying Remote-Port Mirroring Configurations

To display the current configuration of remote port mirroring for a specified session, enter the show config command in MONITOR
SESSION configuration mode.
Dell(conf-mon-sess-2)#show config
!
monitor session 2 type rpm
source fortyGigE 1/32/1 destination remote-vlan 300 direction rx
source Port-channel 10 destination remote-vlan 300 direction rx
no disable
To display the currently configured source and destination sessions for remote port mirroring on a switch, enter the show monitor session
command in EXEC Privilege mode.
Dell(conf)#do show monitor session
SessID Source
------ ------
1 remote-vlan 100
1 remote-vlan 100
2 Fo 1/4/1
2 Po 10
To display the current configuration of the reserved VLAN, enter the show vlan command.
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary, C -
Community, I - Isolated
O - Openflow
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
NUM Status
* 1 Inactive
R 100 Active
R 300 Active
666 Port Monitoring
Destination
-----------
Fo 1/32/1
Po 100
remote-vlan 300
remote-vlan 300
Description
Dir Mode Source IP
--- ---- ---------
N/A N/A N/A
N/A N/A N/A
rx Port N/A
rx Port N/A
Q Ports
T Fo 1/20/1
T Fo 1/24/1
Dest IP
--------
N/A
N/A
N/A
N/A