Removing The Rear Cover - Christie GS Series Service Manual

Removing the rear cover

The rear cover provides access to keypad board and AC inlet module.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and I/O board.
See Replacing the main board and I/O board
3. Remove the four M3 screws with a Phillips #1 screwdriver.
4. Loosen the five captive M3 screws with a Phillips #1 screwdriver securing the rear cover
module.
5. Remove the keypad to LED board harnesses and keypad to main board harness from the clips.
6. To separate the rear cover module, remove the three M3 screws with a Phillips #1 screwdriver.
7. Remove the keypad board.
See Removing the keypad board
8. Remove the AC inlet.
See Removing the AC inlet
9. Transfer the keypad board and AC inlet module to the new front cover.
10. If required, replace the rear cover.
GS Series 1075 Service Manual
020-001236-02 Rev. 1 (12-2019)
on page 63.
on page 83.
on page 91.
on page 74.
Projector covers and feet
64