Projector covers
Learn how to remove the covers of the projector.
Removing the top cover
The top cover provides access to the light engine, electronics, and various other internal components.
1. Loosen the four captive screws securing the top cover.
2. Lift up the top cover to remove it.
If the rigging handles are installed, lift up the top cover to clear the frame, rotate 90 degrees,
and slide the top cover out under the handles.
3. If required, replace the top cover.
4. To install the top cover, repeat these steps in reverse order.
Removing the rear cover
Removing the rear cover provides access to the power supplies and other components allowing
removal of the integrator assembly.
1. Loosen the six captive screws securing the rear cover.
2. Remove the rear cover.
4K40-RGB Series Service Guide–D4K40-RGB, Roadie 4K40-RGB, Mirage 4K40-RGB
020-102960-02 Rev. 1 (12-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
33