YASKAWA SGD7S series Product Manual page 186

Parameter
Name
No.
Application Function
2
Selections A
Motor Stopping Method for Group 2 Alarms

n. X
Pn00A
Stopping Method for Forced Stops
 
n. X
 
n. X Reserved parameter (Do not change.)

n.X Reserved parameter (Do not change.)
Application Function
2
Selections B
Operator Parameter Display Selection

n. X
Motor Stopping Method for Group 2 Alarms
Pn00B
 
n. X
Power Input Selection for Three-phase SERVOPACK
 
n. X

n.X Reserved parameter (Do not change.)
5.1 SERVOPACKs with Analog Voltage/Pulse Train References
Setting Setting
Range Unit
0000 to
–
0044
Apply the dynamic brake or coast the motor to a stop (use the stopping
0
method set in Pn001 = n.X).
Decelerate the motor to a stop using the torque set in Pn406 as the maximum
1
torque. Use the setting of Pn001 = n.X for the status after stopping.
Decelerate the motor to a stop using the torque set in Pn406 as the maximum
2
torque and then let the motor coast.
Decelerate the motor to a stop using the deceleration time set in Pn30A. Use
3
the setting of Pn001 = n.X for the status after stopping.
Decelerate the motor to a stop using the deceleration time set in Pn30A and
4
then let the motor coast.
Apply the dynamic brake or coast the motor to a stop (use the stopping
0
method set in Pn001 = n.X).
Decelerate the motor to a stop using the torque set in Pn406 as the maximum
1
torque. Use the setting of Pn001 = n.X for the status after stopping.
Decelerate the motor to a stop using the torque set in Pn406 as the maximum
2
torque and then let the motor coast.
Decelerate the motor to a stop using the deceleration time set in Pn30A. Use
3
the setting of Pn001 = n.X for the status after stopping.
Decelerate the motor to a stop using the deceleration time set in Pn30A and
4
then let the motor coast.
0000 to
–
1121
0 Display only setup parameters.
1 Display all parameters.
0 Stop the motor by setting the speed reference to 0.
Apply the dynamic brake or coast the motor to a stop (use the stopping
1
method set in Pn001 = n.X).
2 Set the stopping method with Pn00A = n.X.
0 Use a three-phase power supply input.
1 Use a three-phase power supply input as a single-phase power supply input.
5.1.2 List of Parameters
Continued from previous page.
Default Applicable When
Setting Motors Enabled
After
0001 All
restart
After
0000 All
restart
Continued on next page.
Classi- Refer-
fication ence
*1
Setup
*1
Setup
5
5-9