Clutch Cover And Disc; Pilot Bearing; Flywheel - Mazda MX-5 1990 Workshop Manual

H
05UOHX-025
05UOHX-026
FLUSH
05UOHX-027
H-16
CLUTCH UNIT
Removal Note
Clutch cover and disc
1. Install the SST.
2. Loosen each bolt one turn at a time in a crisscross pattern
until spring tension is released. Then remove the clutch cov-
er and disc.
Flywheel
Note
• After removing the flywheel, inspect for
oil leakage
past the crankshaft rear oil seal.
If necessary, replace the oil seal.
(Refer to Section B.)
1. Hold the flywheel with the SST.
2. Remove the flywheel.
Pilot bearing
Remove the pilot bearing with the SST, if necessary.
Installation Note
Flywheel
1. Wipe the bolts clean, and apply sealant to the bolt threads.
2. Install the flywheel and SST.
3. Tighten the bolts in the pattern shown.
Tightening torque:
96-103 N·m (9.8-10.5 m-kg, 71-76 ft-Ib)
Pilot bearing
Note
• Install the pilot bearing flush with the flywheel.
Install the new bearing with a suitable pipe.