Boot Replacement - Mazda MX-5 1990 Workshop Manual

N
BOOT
Replacement
1 . Loosen the wheel lug nuts.
MANUAL STEERING
2. Jack up the front of the vehicle and support it with safety stands.
3. Remove the wheel.
4. Remove in the order shown in the figure, referring to Removal Note.
5. Install in the reverse order of removal, referring to Installation Note.
6. After installation, check the steering angle and toe-in and adjust if necessary. (Refer to Section R.)
®
29-44 (3.0-4.5, 22-33)
REPLACE
®
®
N·m (m-kg, ft-Ib)
05UONX-007
1. Cotter pin
5. Tie-rod end
2. Nut
6. Tie-rod end boot
3. Tie-rod end / Steering knuckle
Removal Note ............................ page N- 7
4. Locknut
Removal/Installation Note ......... page N- 7
7. Boot clam p
8. Boot wire
Removal Note ............................ page N- 7
g. Steering gear boot
N-6
--