Inboard/Outboard Adjustment Of Door Glass - Mazda MX-5 1990 Workshop Manual

s
WINDOW REGULATOR, GLASS, AND GUIDE
2.lnboard/Outboard adjustment of door glass
Adjustment procedure
Remove the weatherstrip, and check alignment with the door glass in the fully-closed position.
(1) Loosen window regulator installation nuts (B) and glass guide installation nut (C).
(2) Adjust by moving the window regulator and the glass guide inward or outward so that the upper and
side edges of the door glass are in the correct position, and then tighten nuts (8) and (C).
Note
• The window regulator and the glass guide should be tightened in approximately the same po-
sition in the slotted adjustment holes. .
• The door glass must raise and lower smoothly with the door closed.
8-12
OUT TOO FAR
~m
B
~ ~~"~TAINER
GLASS ' / / IN TOO FAR
CORRECT P SITION
SEC. A-A
A
GLASS OUT TOO FAR
~
ODe
c:====::!l\\IN
~ia:~
CORRECT POSITION
SEC. B-B
GLASS GUIDE
CONVERTIBLE TOP
DETACHABLE HARD TOP
RETAINER MOUNTING HOLE 0.5
RETAINER MOUNTING HOLE No.1
RETAINER MOUNTING HOLE No.1
15 (0.59)
®
E
E
/ijETAINER MOUNTING HOLE
NO.:
-.llETAINER MOUNTING HOLE No.8
RETAINER
RETAINER
GLAS~
G~srt?
SEC. E-E
SEC. F-F
65 (2.56)
®
b
® 9.3
±
2.0 (0.37
±
0.08)
® 7.4
±
2.0 (0.29
±
0.08)
c
©
5.8 ± 2.0 (0.23 ± 0.08)
@
11.1
±
2.0 (0.44
±
0.08)
16 (0.62)
mm (in)
05UOSX·015