M
DRIVESHAFT
DOUBLE OFFSET JOINT
Inspection / Removal/Installation
DRIVESHAFT
1 . Inspect the driveshaft, referring to Inspection.
2. Remove in the order shown in the figure, referring to Removal Note.
3. Install in the reverse order of removal, referring to Installation Note.
4. After installation, adjust the rear wheel alignment. (Refer to Section R.)
<' @
/
54-64 (5.5-6.5, 40-47)
1 . Rear wheel
2. Locknut
~~~
~J~) '\
~
tf
~46-.7
(4.7-6 .• ,
~4-49)
~.
.'
~rLx)
~'~
~\
u
®REPLACE
~~30' 15.-21~
N·m (m-kg,
ft-Ib)
05UOMX-033
3 Driveshaft
Installation Note""""""."""""" page M-17
Removal Note""""",,"""""""" page
M-16
Overhaul""""",," """ .. "",,",, .... page M-18
05UOMX-035
M-16
Inspection
Driveshaft
1. Check the dust boot on the driveshaft for cracks, damage,
leaking grease, and a loose boot band.
2. Check the driveshaft for bending, cracks, and wear of joints
or splines.
3. Repair or replace the driveshaft if necessary.
Removal note
Driveshaft
Before removing the driveshaft, mark the driveshaft and out-
put shaft for proper installation.