REAMER BOLT
05UOMX·079
05UOMX-083
DIFFERENTIAL
M
4. Verify that the sleeve is installed into the block.
Note
• The reamer bolt is installed in the forward hole.
5. Install the spacer and bolts and snugly tighten them.
6. Snugly install the power plant frame bracket.
7. Tighten the transmission-side bolts.
Tightening torque:
104-123
N·m
(10.6-12.6
m-kg,
77-91
ft-Ib)
8. Tighten the differential-side bolts.
Tightening torque:
104-123
N·m
(10.6-12.6
m-kg,
77-91
ft-Ib)
9. Install the power plant frame bracket.
Tightening torque:
®
104-123
N·m
(10.6-12.6
m-kg,
77-91
ft-Ib)
®
36-54
N·m
(3.7-5.5
m-kg,
27-40
ft-Ib)
10. Remove the jack, and connect the wire harness.
Propeller shaft
1. Remove the SST.
2. Align the marks, and install the propeller shaft.
Tightening torque:
27-30
N·m
(2.8-3.1
m-kg,
20-22
ft-Ib)
M-31